Icom IC-PW2 - Page 67

To Next Page

To Previous Page

MEMO

Main Page

Important2
Features2
Supplied Accessories2
Explicit Definitions3
About Ce and Doc3
Disposal3
About Ukca Doc3
About Spurious Signals3
Fcc Information3
About the Touch Screen4
About the Manuals4
Trademarks4
About the Instructions5
Installation Notes6
Precautions7
Table of Contents8
Panel Description10
Front Panel10
Rear Panel11
Touch Screen Display13
D MENU Screen15
D QUICK MENU Screen15
Keyboard Entering and Editing15
D Entering and Editing Characters15
D Keyboard Types16
D Entering and Editing16
D Entering and Editing Example17
Installation and Connections18
Attaching the Controller18
Using the Controller Separately from the Main Unit18
D Detaching from the Main Unit18
D Connecting the Controller Cable19
D Attaching the Mounting Bracket Stand19
D Attaching to a Flat Surface19
Select a Location19
Heat Dissipation19
Grounding19
Connecting the AC Power Cable20
D about the Power Supply Voltage20
D about an AC Power Plug20
Exciter20
Antenna20
D Impedance20
D about the Maximum Input Power20
Connecting to Exciters21
D Connecting 2 Icom Exciters to [INPUT 1] and [INPUT 2]22
D Connecting 1 Icom Exciter to [INPUT 1]22
D Connecting 1 Icom Exciter to [INPUT 2]23
D Connecting 1 Icom Exciter to [INPUT 1] and [INPUT 2]23
D Connecting 1 Icom and 1 Non-Icom Exciter to [INPUT 1] and [INPUT 2]24
D Connecting 1 Non-Icom Exciter to [INPUT 1]24
D Connecting 2 Non-Icom Exciters to [INPUT 1] and [INPUT 2]25
Initial Setup26
Before Initial Setup26
CI-V Settings26
D CI-V Address26
D CI-V Baud Rate26
D CI-V Transceive Function26
Turning Power on or off26
Connection Mode26
D Setting the Exciter Connection26
D Switching the Display Layout of [INPUT 1] and [INPUT 2]27
D the CI-V Settings of [INPUT 1] and [INPUT 2]27
D Synchronization with the Exciter28
ALC Adjustment28
Basic Operation31
Operation Modes31
D Antenna Selector Mode31
D Antenna Tuner Mode31
D Linear Amplifier Mode31
Changing the Status of [INPUT 1] and [INPUT 2]32
D Using the RF Input Selector32
D Using the Touch Screen Display32
Switching the Maximum Output Power32
Selecting the Frequency Band32
Selecting the Antenna Connector33
D Using the Antenna Selector33
D Using the Touch Screen Display33
ANT Key Display Settings34
Antenna Memory34
RX-I/O Setting35
Meter Display36
D Displaying the Multi-Function Meter36
D about the HOT Zone of the TEMP Meter36
Confirmation before Transmitting36
Antenna Tuner Operation37
About the Internal Antenna Tuner37
About Manual Tuning37
Sd Card38
About the SD Cards38
Saving Data38
Inserting38
Formatting38
Unmounting39
Saving the Setting Data39
Loading the Saved Data40
Deleting a Data File41
Displaying the SD Card Information41
About the SD Card's Folders42
Set Mode43
Set Mode Description43
Function44
Connectors44
Network46
Display46
Time Set48
SD Card48
Others49
Other Functions50
Protection Function50
D about the Cooling Fan50
D Types of the Protection Function50
Clock and Timers51
D Setting the Date51
D Setting the Current Time51
NTP Function52
D Using the NTP Time Synchronize Function52
D Using the NTP Function52
Screen Capture Function52
D Setting the Screen Capture Function52
D Capturing a Screen52
D Viewing the Captured Screen52
Displaying My Call Sign53
Digital Pre-Distortion (DPD) Function53
D Connecting with the Icom Exciter53
D the DPD Adjustment and Operation53
Maintenance54
Resetting54
D Partial Reset54
D All Reset54
Touch Screen Calibration Function55
Cleaning55
Clock Backup Battery Replacement56
Troubleshooting57
Updating the Firmware60
General60
D about Updating the Firmware60
D Checking the Firmware Version60
D Preparation61
D Unzipping the Firmware Folder61
Updating the Firmware62
Specifications and Options63
Specifications63
D General63
D Antenna Tuner63
Options63
Connector Information64
[Input 1]/[Input 2]64
[Rx-Ant In]/[Rx-Ant Out]64
[Input 1/2]64
[Lan]64
[Remote Aux]64
[ANT 1] to [ANT 6]64
[Acc 1]/[Acc 2]65
[Remote 1]/[Remote 2]65
[Send 1]/[Send 2]65
[Alc 1]/[Alc 2]65
[Band 1]/[Band 2]65
About the Licenses66

Icom IC-PW2 - Page 67

Table of Contents

Related product manuals