Icom ID-51A - Calling an Individual Station

58
6
D-STAR OPERATION
New2001
6
New2001
Push D-pad( e ) to select the
repeater group where your
destination repeater is listed,
and then push D-pad(Ent).
 •Example:“11:Japan”
Push D-pad( r ) to select the
destination repeater, and
then push D-pad(Ent).
 •Example:“Hamacho430”
Holddown[PTT]totransmit3.
Whileholdingdown[PTT],speak
at your normal voice level.
•“/”isautomaticallyinsertedtoshow
it is a repeater call sign.
Transmitting
Convenient! ✓
TheGatewayCQcallisusedtocallanyrepeater,butyoucan
call a specific station by simply saying their call sign.
■ Callinganindividualstation
You can make a call to an individual station when the station
call sign is selected in “TO” (Destination).
When you call an individual station call sign through a gate-
way, your call is automatically sent to the last repeater that
the station accessed. So, even if you don’t know where the
station is, you can make a call using call sign routing.
Set“FROM”(Accessrepeater)1.
Push D-pad( q ) to select
“FROM,” and then push D-
pad(Ent).
Push D-pad( w ) to select “Re-
peater List,” and then push
D-pad(Ent).
D-pad
(�)
(Ent)
Push D-pad( e ) to select the
repeater group where your
access repeater is listed, and
then push D-pad(Ent).
 •Example:“11:Japan”
Go to step r
D-STAR OPERATION
Continued on the next page ☞