Icom ID-51A Basic Instructions

60
6
D-STAR OPERATION
New2001
6
New2001
PROBLEM POSSIBLECAUSE SOLUTION REF.
After your call, the repeater does
not return a status reply.
•Therepeatersettingiswrong.
•Yourtransmissiondidnotreachtherepeater.
•Selectthecorrectrepeater.
•Correcttherepeaterfrequency,frequencyoff-
set, or duplex settings.
•Wait until you are closer to the repeater and
try again.
•Trytoaccessanotherrepeater.
p. 47
—
—
After your call, the repeater re-
plies‘UR?’anditscallsign.
•Thecallwassuccessfullysent,butnostation
immediately replied.
•Waitforawhile,andtryagain. —
After your call, the repeater replies
‘RX’or‘RPT?’andtheaccessre-
peater’s call sign.
•Yourowncallsign(MY)hasnotbeenset.
•Yourowncallsign(MY)hasnotbeenregis-
tered on a gateway repeater, or the registered
contents do not match your transceiver’s set-
ting.
•Setyourowncallsign(MY).
•Registeryourowncallsign(MY)onagateway
repeater, or confirm the registration of the call
sign.
p. 13
p. 15
After your call, the repeater re-
plies‘RPT?’ and call sign of the
destination repeater.
•Therepeatercannotconnecttothedestina-
tion repeater.
•Therepeateris busy.
• Check the repeater setting.
• Wait for a while, and try it again.
p. 57
—
■ Troubleshooting
To communicate through the repeater, your signal must access to the repeater. When your signal accesses your local repeater,
but it is not sent to the destination repeater, the repeater replies with an status message.
D-STAR OPERATION
Continued on the next page ☞

Icom ID-51A Specifications

General

Frequency Range	144-148 MHz, 430-450 MHz
Antenna Connector	SMA
GPS Receiver	Yes
Waterproof	IPX7
Modes	FM, DV
Weight	255 g
Memory Channels	1304 channels
Output Power	5W (High), 2.5W (Middle), 0.5W (Low)