Icom ID-51A Basic Instructions

New2001
50
6
D-STAR OPERATION
6
Checkwhetheryoucanaccesstherepeater3.
Holddown[PTT]forapproxi- q
mately 1 second to access
the repeater.
Transmitting
Ifyougetareplycall,or“UR?” w
appears on the LCD within 3
seconds, your signal reached
your access repeater and
your call was successfully
sent from your destination
repeater.
Successfullysent!
NOTE: See page 60 for status indications after a reply is
received.
■ UsingtheRXhistory
When a DV call is received, the call signs of the caller, the
called station and the called station’s access repeater are
stored in the RX history file.
Up to 50 calls can be stored.
This section describes how to view the RX history screen and
how to save the call sign to memory.
The S-meter appears
and the caller’s call
sign is displayed.
Whenreceivingacallfrom“JM1ZLK.”
D-STAR OPERATION
Continued on the next page ☞

Icom ID-51A Specifications

General

Frequency Range	144-148 MHz, 430-450 MHz
Antenna Connector	SMA
GPS Receiver	Yes
Waterproof	IPX7
Modes	FM, DV
Weight	255 g
Memory Channels	1304 channels
Output Power	5W (High), 2.5W (Middle), 0.5W (Low)