Icom ID-51A - Menu Items and Their Details

20
3
MENU SCREEN
New2001
3
MENU SCREEN
New2001
DUP/TONE...
Settings to access repeaters.
OffsetFreq
Sets the frequency offset for duplex (repeater) operation.
RepeaterTone
Selects a tone frequency used to access the repeaters.
TSQLFreq
Selects a tone frequency for the Tone squelch or the pock-
et beep function.
ToneBurst
Turns the Tone Burst function ON or OFF.
This function is used to suppress the squelch tail noise
heard from the transceiver’s speaker.
DTCSCode
Selects a DTCS (both encoder/decoder) code for DTCS
squelch or the pocket beep function.
DTCSPolarity
Selects the DTCS polarity for the DTCS squelch or the
pocket beep function.
DigitalCode
Selects a digital code for the Digital Code squelch func-
tion.
Scan
Set scan options.
PauseTimer
Selects the scan pause time. When receiving signals, the
scan pauses according to the scan pause timer.
ResumeTimer
Selects the scan resume time from a pause after the re-
ceived signal disappears.
TemporarySkipTimer
Selects the Temporary Skip Time. When the time is set,
specified frequencies are skipped for this period during a
scan.
ProgramSkip
Turns the Program Skip Scan function ON or OFF for a
VFO mode scan.
BankLink
Selects banks to be scanned during a Bank Link Scan.
ProgramLink
Sets the link function for the program scan edge channels.
See the Advanced Instructions for details of the preset values.
■ Menuitemsandtheirdetails
This topic describes the Menu items and their details.