Icom ID-51A

80
9
RESETTING
New2001
■ Resetting
The display may occasionally display erroneous information.
This may be caused externally by static electricity or by other
factors. If this problem occurs, turn OFF power. After waiting
a few seconds, turn ON power again. If the problem persists,
perform a Partial reset or an All reset.
BE CAREFUL! An All reset clears all programming and
returns all settings to their factory defaults. See the PDF
type Advanced Instructions for more details.
A Partial reset resets operating settings to their default values
(VFO frequency, VFO settings, menu contents) without clear-
ing the items below:
•Memorychannelcontents •ScanEdgecontents
•Callchannelcontents •Callsignmemories
•Messagedata •DTMFmemorycontents
•GPSMemorycontents •Repeaterlist
•BCRadioMemory
q Push [MENU]
to enter the
Menu screen.
Push D-pad( w ) to select “Par-
tial Reset,” and then push D-
pad(Ent).
D-pad
(�)
(Ent)
( Others > Reset > Partial Reset)
 •If the item is not displayed, push
D-pad() one or more times to se-
lect the page.
The “Partial Reset?” dialog e
appears.
Push D-pad( r ) to select “Yes,”
and then push D-pad(Ent).
 •Thetransceiver displays“PAR-
TIAL RESET,” then the partial
reset is completed.
Defaultscreen
Shows “PARTIAL RESET”
D Partialreset
Go to step r
9
RESETTING