Danger
cables with damages.
●
Do not remove the housing or cover plates when the welder is in use.
●
Wear insulation gloves with good insulation performance and without damages.
●
Take safety measures when doing tasks at high places.
●
Disconnect the power supplies of the welder and distribution box when the welder is not used.
●
When performing welding in narrow or confined space, adopt supervision and ensure good
ventilation or use respiratory protection tools; failing to do so may result in asphyxia due to
hypoxia.
●
Hazardous smoke, dust, and gas may be generated during welding. Ensure good ventilation or
use respiratory protection tools; failing to do so may result in injuries.
●
Do not weld pressure vessels that contain gas, such as air pipes and seal pots.
●
Do not move hot workpieces close to combustible materials.
●
Do not perform welding near combustible materials.
●
Deploy fire extinguishers near welding sites.
●
Fix gas cylinders using only dedicated stands; failing to do so may result in injuries when the gas
cylinders fall down.
●
Do not connect electrodes with gas cylinders.
●
Follow instructions to correctly use pressure reducing valves.
●
Only professional personnel are allowed to disassemble and repair pressure reducing valves.
●
Do not touch the rotating parts such as the fan and wire feeder when the welder is in use; failing
to do so may result in injuries.
●
When performing or supervising welding, use protective equipment with sufficient shading
degree to prevent arc from harming eyes or skin.
●
Use protection gears, such as welding-dedicated protection leather gloves, clothes with long
sleeves, foot protection, aprons, and goggles, to protect against arc, spatters, and welding slag.
●
Set up protective barriers around welding sites to prevent arc from injuring others.
●
Use soundproof devices to prevent noise hazards.
Note
!
●
Do not use this welder for tasks other than welding.
●
Do not place heavy objects on the welder.
●
Do not seal or block the air vents of the welder.
●
Place the welder at places where metal objects such as spatters are unable to enter the welder.
●
Keep the welder at least 30 cm away from walls and other welder.
●
Use screens to prevent wind from directly blowing against arc.
To Next Page
Loading...
