14 - 2
IPN 074-505-P1E
IC6 Operating Manual
14.3 Configuration Files
With the instrument in the READY state, the configuration of the IC6 may be sent
to a storage device attached to the USB port. Configuration files will be written with
the default name IC6.ISC. The configuration file can be named within the
eight-character limitation that exists in the USB file handling firmware. File names
cannot contain the space character. The IC6 will use the .ISC extension to identify
configuration files. The IC6 will ignore or reject IC/5 and Cygnus .ISC configuration
files—these files are not compatible with the IC6. See Figure 14-1.
Figure 14-1 Configuration files
NOTE: The IC6 must be in the READY mode to save a configuration file.
To Next Page
Loading...
