15 - 14
IPN 074-505-P1E
IC6 Operating Manual
15.6 Input Error Messages
Keyboard Input Error Messages come up on the entry of invalid parameters. These
messages will appear on the transient error message line in the message box. The
font color of the parameter value being updated will change to a different color to
denote an input error has been made. They will clear when the clear key is pressed.
The original stored value will then be re-displayed. See Table 15-6.
Table 15-6 Input error messages
Input Error Message Set Cleared Screen
Value Too High The value entered is larger than the maximum
value allowed.
Each input error
message is
taken down by
pressing the
clear key.
Any Parameter
edit
Value Too Low The value entered is lower than the minimum
value allowed.
Any Parameter
edit
Duplicate Source Can use each source number only once for
thickness sum.
General
Duplicate Sensor The single or one of the multipoint sensors for
the material cannot also be set as the backup
sensor.
Material
Empty Process Can’t select an empty process as process to run. General
Invalid Mask An attempt was made to enter an incorrect
Ethernet net mask.
General
Incorrect Time An attempt was made to enter more then 59
seconds or 99 minutes into a time parameter.
Material
Must use one sensor In multi-point mode, at least one sensor for each
defined material must have its option parameter
non-zero.
Material
Ramp 1 > Ramp 2 Invalid material parameter ‘Ramp’, values were
entered. Start Ramp 1 thickness value must be
less then Start Ramp 2 value when the Start
Ramp 2 value is non-zero.
Material
Ramp 2 < Ramp 1 Invalid material parameter ‘Ramp’, values were
entered. Start Ramp 2 thickness value must be
greater then Start Ramp 1 value.
Material
Sensor in use An attempt is being made to turn on a sensor
that is already in use for the other material of a
co-deposited material.
Material
Bad Crystal and Running An attempt is being made to turn on a sensor
that is bad and the Material is running.
Material
Co-Dep Uncalibrated An attempt is being made to turn on a sensor
that is not calibrated for Co-Dep.
Material
To Next Page
Loading...
