180
Chapter 4
Emulation Configuration Menu
UPC Descenders
This parameter determines if a gap is left for human readable data in UPC/
EAN bar codes, even if there is no human readable data. There will be no
change if there is human readable data.
•
Enable (the default). Leaves a gap even if there is no human readable
data.
•
Disable. Does not leave a gap if there is no human readable data.
Rotate Character Size
The Rotated Character Size option determines if rotated (clockwise/counter-
clockwise), expanded characters have a different size than a non-rotated
character with the same size parameters (Adjusted) or the same size (Not
Adjusted).
•
Adjusted (the default)
•
Not Adjusted
Ignore Spaces
•
Disable (the default). Trailing spaces are NOT deleted from
alphanumeric elements in a graphics pass.
•
Enable. Trailing spaces are deleted from alphanumeric elements in a
graphics pass.
Midline PY
•
Enable (the default). Allows printable characters to precede the ^PY
command.
•
Disable. Requires the ^PY command to be the first characters on a line.
Dark Barcode
•
Disable (the default). Bar codes are printed in normal mode.
•
Enable. When enabled, prints all bar codes in a dark mode.
Expanded Font
•
Block (the default). These are block characters compatible with the IGP-
X00 printers.
•
Scalable. These expanded characters have rounded edges.
LP+ Font
•
Disable (the default). The IGP/VGL uses its default half-dot font, which is
slightly different from the standard bitmap font used by LP+ at 12, 13, 15
and 17 cpi.
•
Enable. The IGP/VGL uses the same font as used by LP+ at all cpi.
To Next Page
Loading...