Code V Emulation Menu
181
Width Limit
•
Disable (the default). This does not limit the width of expanded
characters.
•
Enable. When enabled, limits the width of expanded characters based on
a fixed maximum ratio of width over height.
Absorb at ^PN
•
Disable (the default). When disabled, system terminators following the
(cc)PN command are sent to the printer and result in paper motion.
•
Enable. Prevents paper motion following the (cc)PN command.
IGP110 Compatibility
•
Enable (the default). This menu will process ^IPEXP commands in the
same manner the IGP does, and does not expand special font characters
if an ^IPEXP command precedes it.
•
Disable. If disabled, it will allow the special font characters to be
expanded.
Inline Graphics
•
Disable (the default). Requires the printer move to the beginning of the
line to start a graphic.
•
Enable. Permits Code V graphics to start in the middle of a print line as
opposed to moving to the beginning of the line to start a graphic.
LF For Term
•
Disable (the default). The LF command ( ^, ) used to terminate a graphic
command sequence will not be performed as LF.
•
Enable. The LF command ( ^, ) used to terminate a graphic command
sequence will be performed as LF.
Ignore ^Lxx Cmd.
•
Disable (default).
•
Enable. The ^Lxx command will always be ignored.
Error Handling
Error Messages
•
Enable (the default). Checks command syntax and prints error
messages when command parameters are incorrect.
•
Disable. Suppresses error checking and error messages.
To Next Page
Loading...