InfoPrint 6500 - Page 244

244
Chapter 7 Fault Messages
010 PARAMETER ERROR No Illegal parameter
value received in
command code over a
CT interface.
Contact your system
administrator.
011 SCS COMMAND ERROR No In CT emulation, the
printer received
undefined control
character (hex 40).
Contact your system
administrator.
012 STRUCTURED FLD
ERROR
No Applications software
has violated
structured data field
parameters.
Contact your system
administrator.
013 ACTIVATE LOST No The printer detects a
twinax protocol
communication error
and reports the error.
Power off the printer.
014 INVALID ACTIVATE No Printer detects Twinax
protocol
communications error
and reports the error.
The printer reports the
error.
015 COMMUNICATION
CHECK
CHECK CABLE
Yes Communication
check: a message
that appears in the CT
emulation indicating
that the line is not
active on a Twinax
interface.
Check cable connection.
016 INVALID COMMAND No Printer detects Twinax
protocol
communications error
and reports the error.
The printer reports the
error; host action is
required.
017 STACKER JAM Yes Paper is jammed in
the power stacker
area.
1. Open the cabinet rear
door and check for
obstructions preventing
elevator movement.
Remove any obstructions.
2. Run the print job again.
If the message reappears,
contact your InfoPrint
service representative.
Table 9: Fault Messages
Fault Message
Operator
Correctable?
Explanation Solution