InfoPrint 6500 - Page 250

250
Chapter 7 Fault Messages
083 INTAKE FAN CHECK*
SEE USERS MANUAL
Yes Sensors cannot
detect current in fan
circuit.
Power off the printer.
Check for obstruction of
vents and fan airway;
remove any obstructions.
Check for items beneath
the printer blocking cabinet
vents. Power back on the
printer. If this message
reoccurs, contact your
InfoPrint service
representative.
084 POWER 48V CHECK*
SEE USERS MANUAL
No Controller voltage
failure. 15 V faiure on
the controller board.
Contact your InfoPrint
service representative.
085 CONTROL VOLT
CHECK
SEE USERS MANUAL
No Controller voltage
failure.
Contact your InfoPrint
service representative.
086 CONTROL 15V CHECK*
SEE USERS MANUAL
No Controller voltage
failure.
Contact your InfoPrint
service representative.
087 PLATEN OPEN
TIMEOUT
CLOSE PLATEN
Yes In the CT emulation
with a coax interface,
the platen lever has
been open for at least
one minute.
Lower (close) the platen
lever.
088 CONTROL 23.5V
CHECK*
SEE USERS MANUAL
No Controller voltage
failure.
Contact your InfoPrint
service representative.
089 RIBBON STALL
CHECK TRANSPORT
Yes The controller board
does not detect ribbon
movement.
Make sure the ribbon is not
twisted and the platen lever
is set to match thickness of
media being used. If fault
reoccurs, contact your
InfoPrint service
representative.
090 SHUTTLE COVER
OPEN
CLOSE SHUTTLE COVER
No Shuttle cover is
missing, damaged, or
not correctly installed.
Contact your InfoPrint
service representative.
Table 9: Fault Messages
Fault Message
Operator
Correctable?
Explanation Solution