InfoPrint 6500 - Page 254

254
Chapter 7 Fault Messages
135 INVALID STATE*
SEE USERS MANUAL
No Platen invalid state.
Fatal firmware error
on the controller
board.
Contact your InfoPrint
service representative.
136 INVALID PARAMETER
SEE USERS MANUAL
No Platen invalid
parameter. Fatal
firmware error on the
controller board.
Contact your InfoPrint
service representative.
137 SHUTL INVALID
COMMAND*
SEE USERS MANUAL
No Shuttle invalid
command. Fatal
firmware error on the
controller board.
Contact your InfoPrint
service representative.
138 SHUTTLE INVALID
PARAMETER
No Shuttle invalid
parameter. Fatal
firmware error on the
controller board.
Contact your InfoPrint
service representative.
139 OVER SPEED CHECK*
SEE USERS MANUAL
No The shuttle is running
over speed. Fatal
firmware error on the
controller board.
Contact your InfoPrint
service representative.
140 48 VOLTS FAILED*
SEE USERS MANUAL
No The power supply is
not generating a
proper 48 Volts, or the
controller board is not
detecting a 48 Volt
output from the power
supply board.
Contact your InfoPrint
service representative.
142 PAP FEED DRIVE FAIL*
SEE USERS MANUAL
No Paper feed drive
failed. The paper feed
driver circuit on the
controller board is
drawing too much
current.
Contact your InfoPrint
service representative.
143 SHUTL DRIVER FAILED*
SEE USERS MANUAL
No Shuttle driver failed.
The shuttle driver
circuit on the
controller board is
drawing too much
current.
Contact your InfoPrint
service representative.
144 SHUTTLE FAN
FAILURE*
SEE USERS MANUAL
No The shuttle fan fails to
blow correctly.
Contact your InfoPrint
service representative.
Table 9: Fault Messages
Fault Message
Operator
Correctable?
Explanation Solution