InfoPrint 6500 - Page 255

Fault Correction Procedure
255
146 RIBBON INK OUT
INSTALL NEW IPS RIBBON
Yes Integrated Print
Management System
software has
determined that the
ribbon is out of ink.
Replace the ribbon and
verify ribbon life is reset to
100%.
147 H/B CONTROL MODE
SEE USERS MANUAL
No One or more hammer
coils are overheating.
Contact your InfoPrint
service representative.
148 DRIVER CIRCUIT BAD
SEE USERS MANUAL
No Driver circuit is faulty.
The hammer coil
count test failed.
Contact your InfoPrint
service representative.
149 HMR BANK NOT
INSTALLED
SEE USERS MANUAL
No Hammer bank not
installed.
Contact your InfoPrint
service representative.
150 ERROR: EC STOPPED
AT STATE XXXX
No XXXX is a number
from 0000 to 0010.
The Entine Controller
has stopped and is in
the state identified by
the number displayed.
Contact your InfoPrint
service representative.
159 HAMMERBANK HOT No The hammerbank is
overheating.
Contact your InfoPrint
service representative.
160 ERROR: DC PROGRAM
NOT VAILID
No The printer cannot
find the data controller
program or the
validation checksum
is corrupt.
Contact your InfoPrint
service representative.
161 ERROR: DRAM AT
ADDRESS XXXXXXXX
No The printer found a
defective memory
location.
Contact your InfoPrint
service representative.
162 ERROR: EC PROGRAM
NOT VALID
Yes The printer cannot
find the engine
controller program or
the validation
checksum is corrupt.
Download the program
again. If the fault message
appears again, contact
your InfoPrint service
representative.
163 ERROR: FLASH DID
NOT PROGRAM
Yes The printer
encountered an error
trying to program
flash memory.
Download the program
again. If the fault message
appears again, contact
your InfoPrint service
representative.
Table 9: Fault Messages
Fault Message
Operator
Correctable?
Explanation Solution
Fault Messages