InfoPrint 6500 - Page 256

256
Chapter 7 Fault Messages
164 ERROR: SDRAM JEDEC
MISSING
No The printer could not
find JEDEC table for
sdram, using default
values.
Contact your InfoPrint
service representative.
165 ERROR: NO DRAM
DETECTED
No The printer could not
find any DRAM.
Contact your InfoPrint
service representative.
166 ERROR: NVRAM
FAILURE
No The non-volatile
SRAM on the
controller board has
failed.
Contact your InfoPrint
service representative.
167 ERROR: PROGRAM
NEEDS MORE DRAM
No The printer requires
more DRAM to run
the downloaded
program.
Contact your InfoPrint
service representative.
168 ERROR: PROGRAM
NEEDS MORE FLASH
No The printer requires
more flash memory to
run the downloaded
program.
Contact your InfoPrint
service representative.
169 ERROR: PROGRAM
NOT COMPATIBLE
No The printer is not
compatible with the
downloaded program.
Contact your InfoPrint
service representative.
170 ERROR: PROGRAM
NOT VALID
No The printer does not
see a program in flash
memory.
Contact your InfoPrint
service representative.
171 ERROR: SHORT AT
ADDRESS XXXX
No Hardware failure in
DRAM or controller
circuitry.
Contact your InfoPrint
service representative.
172 ERROR: WRITING TO
FLASH
No Hardware or software
fault in flash memory.
Contact your InfoPrint
service representative.
173 ERROR: WRONG
CHECKSUM
No The printer received
the complete program
but the checksum did
not match.
Contact your InfoPrint
service representative.
174 ERROR OCCURRED
FLUSHING QUEUES*
No An interim message
that displays while the
printer discards host
data it cannot use
because a fault
condition exists.
Contact your InfoPrint
service representative.
Table 9: Fault Messages
Fault Message
Operator
Correctable?
Explanation Solution