InfoPrint 6500 - Page 257

Fault Correction Procedure
257
175 ACCESS NULL
POINTER*
SEE USERS MANUAL
No Application software
tried to perform an
illegal printer function
or damaged logic
circuits were detected
on the controller
board.
Contact your InfoPrint
service representative.
180 ETHERNET ADDRESS
ADAPTER NOT INSTALLED
Yes The Ethernet PCBA is
not enabled or did not
initialize correctly.
Install the Ethernet
Address Adapter.
181 ETHERNET ADAPTER
BEING INITIALIZED
N/A Status message
indicating that the
ethernet interface is
processing the boot
procedure.
No action required.
182 ETHERNET DETECTED N/A Status message
indicating that the
ethernet interface has
established
communication.
No action required.
190 SECURITY ERROR
SEE USERS MANUAL
No Security Key intended
for ribbon use
installed on CDB
machine.
Contact your InfoPrint
service representative.
191 SECURITY CODE
VIOLATION
No Security Key does not
match emulation.
Contact your InfoPrint
service representative.
192 SECURITY KEY NOT
DETECTED
No The security key is not
present or has failed.
Contact your InfoPrint
service representative.
194 INCOMPAT. E-NET NIC
REPLACE NIC
No The Ethernet installed
in the printer is not the
correct part number
for the 6500-V printer.
Contact your InfoPrint
service representative.
195 INCOMPAT. WLAN NIC
REPLACE NIC
No The wireless Ethernet
installed in the printer
is not the correct part
number for a 6500-V
printer.
Contact your InfoPrint
service representative.
Table 9: Fault Messages
Fault Message
Operator
Correctable?
Explanation Solution
Fault Messages