InfoPrint 6500 - Page 264

264
Chapter 7 Fault Messages
CALIBRATION ERROR
SEE USERS MANUAL
No This fault appears if
the calibration values
stored in the printer
are no longer valid.
Contact your InfoPrint
service representative.
CALIBRATE TRANSPORT
PRESS ENTER KEY*
N/A If the CDP system
detects the installation
of a new transporter,
an autocalibration
cycle initializes.
No action required.
CALIBRATING TRANSPORT
PLEASE WAIT...
N/A Status message:
displays when the
Transport calibration
starts.
No action required.
CLEARING PROGRAM
FROM FLASH
N/A Status message:
emulation software
successfully loaded
into printer RAM and
the checksum
matched. The old
program is now being
deleted from flash
memory.
No action required.
CRTG COMM ERR
SEE USERS MANUAL
No The hardware cannot
communicate properly
with the cartridge.
1. Make sure the ribbon
cartridge is seated
properly.
2. Remove and replace
the ribbon cartridge if
necessary.
3. Contact your InfoPrint
service representative.
CRTG MISSING
Install new RBN
Yes The ribbon cartridge
is missing or installed
improperly.
1. Make sure a ribbon
cartridge is installed in
the printer.
2. Make sure the ribbon
cartridge is seated
properly.
3. Remove and replace
the cartridge if
necessary.
4. Contact your InfoPrint
service representative.
Table 9: Fault Messages
Fault Message
Operator
Correctable?
Explanation Solution