InfoPrint 6500 - Page 284

284
Chapter 7 Fault Messages
OPERATOR MENU
UNLOCKED
N/A Non–error status
message.
No action required.
P00 ERROR:SYSTEM FAULT Yes Firmware error on the
controller board.
Cycle power. Run the print
job again. If the message
appears, download the
emulation software again.
If the message appears
again, contact your
InfoPrint service
representative.
P05 DIAGNOSTIC TEST
PASSED
N/A Non–error status
message.
No action required.
P17 SECURITY VIOLATION No Security code of PAL
on controller board
does not match code
of firmware on the
controller board.
Contact your InfoPrint
service representative.
PA1 SELECTED N/A Attach status
message.
No action required.
PA2 SELECTED N/A Attach status
message.
No action required.
PAP FD DRVR CIR*
SEE USERS MANUAL
No Paper Feed Driver
Circuit. The paper
feed driver circuit on
the controller board is
drawing too much
current.
Contact your InfoPrint
service representative.
PRINTER UNDER REMOTE
CONTROL
Yes Indicates that remote
management software
has control of the
printer.
No action required.
QUEUE OVERRUN No In CT twinax
emualtion, the print
buffer has overflowed.
Contact your InfoPrint
service representative.
READY N/A Printer state
message: printer is
online and in
communication with
host.
No action required.
Table 9: Fault Messages
Fault Message
Operator
Correctable?
Explanation Solution