16 Programming peripherals
Centrali anti-intrusione
3-3
Expansions
3-3-1
Setting up expansions
Via software
Once the solution of the installation to be designed has been opened, access the “System
layout” section on the right. Here you can select the expansion to be configured and add it to
the configuration by double-clicking on the mouse.
The section on the left allows you to indicate the number of expansions via the respective
button.
To remove an expansion from the structure, access the programming section by clicking on
the relative key in the menu on the left then, from the list displayed, click on the
Delete
button that corresponds to the line of the expansion to be deleted.
Via keypad
Type-in Code
(Installer PIN)
, PROGRAMMING Expansions, Enablements
This section allows you to add/remove expansions from the configuration, by means of keys
and .
WIRELESS
EXPANSIONS
During the enrolling phase the Air2-BS200 wireless transceiver is integrated into the Prime
system by simulating:
• a reader, with the address programmed via the module itself (ADD), by means of buttons
P1 and P2 on the PCB (for details refer to the Module manual)
• up to 10 expansions, at addresses ADD, ADD+1, ... ADD+9, to manage terminals and to
be configured using the “System Layout” page in the Prime/STUDIO software.
Via software
To identify an expansion as “wireless”, it must first be configured as described above, in the
same way as the hardwired expansions.
Following that, click-on the
Terminals
button. The “Programming” section on the right will
show the diagram of the terminals of the entire system.
Right click-on the expansion previously added to the configuration and select “Wireless” to
qualify it as such. The “Wireless”.symbol will appear on the image of the expansion. The
configuration is completed by enrolling the wireless devices.
Via keypad
Type in Code
(Installer)
, PROGRAMMING Terminals,
select a terminal of an expansion
The button enables the wireless attribute on the terminal (and consequently on the
entire expansion). The “Wireless” string will be shown on the bottom line of the display. If you
press key again, the entire operation will undo.
3-3-2
Programming expansions
Programming of expansions as peripherals of the Prime system can be performed either via
software or from a keypad.
Via software
Click-on the
Expansions
button on the menu on the left, the “Programming” section on the
right will show a list of configured expansions. By selecting one of these items it is possible to
set the parameters of the single expansion by clicking on the button.
Via keypad
Type in Code
(Installer)
, PROGRAMMING Expansions, ChoosePeripheral
This section allows you to program the various options of the selected expansion.
3-3-3
Expansion parameters
Terminals 12345
EXPAN. XYZ IIII
Expans. XYZ T01
Wireless
Table 3-6: Parameter single expansion
Parameter Software section Installer menu section
Description
Description string of the expansion (to be customized
by the installer).
Configured
expansions,
selected expansion
Expansions, ChoosePe-
ripheral, "expansion"
Beep on output
This option enables/disables the buzzer of the
selected expansion when terminal T1, configured as
an output, activates.
Expansions, ChoosePe-
ripheral, "expansion",
Options
To Next Page
Loading...