INIM Electronics Prime - 11-2 Telephone line

Programming manual
Programming the telephone 53
“SIA-IP” TYPE If a telephone number is “SIA-IP” type, the IP address and port of the SIA-IP receiver must be
entered in the receiver number field in the “Number” section, using the following format:
xxxyyyzzzttt,ppppp
where:
- “xxxyyyzzzttt” are the 4 octets of the IP address (standard IPv4), each of which should be
written with 3 figures and, if necessary, “0” filler characters and no separation points.
- “ppppp” is the port and should be written with 5 figures and, if necessary, “0” filler
characters.
POLLING SIA-IP If a telephone number is a "SIA-IP" type number, it is possible to enable the “polling” function.
In this way, from this number the control panel sends a periodic signal to the receiver SIA-IP
server, which can verify proper functioning of the transmission. The parameters of the polling
periodicity are available in the “Telephone parameters” section (
Table 11-2: Telephone
parameters
).
ACCOUNT CODE Some protocols (reporting formats) accept digits only, whilst others accept also “A”, “B”, “C”,
“D”, “E” and “F”, available using keys .
11-2
Telephone line
Channel
Selection box for the channel on which you can route
the call:
•PSTN
•Nexus
•LAN
Encryption
This field allows you to select the SIA-IP protocol
encryption type:
•None
• AES 128 bit
• AES 192 bit
• AES 256 bit
After selecting the type is is necessary to indicate
the encryption key.
Receive SMS
This option allows the telephone number to receive an
SMS message from the Nexus GSM module, as well as
all other event-related communications.
Telephone, Selected
number, "number", Op-
tions
Toggle channel
on call failure
This option, in the event of call failure on a channel,
enables the control panel to carry out call attempts on
an alternative channel (Nexus) and then retry on the
original channel in order to alternate the set number
of attempts.
SIA-IP
If a telephone number is configured as “SIA-IP”, you
must program the IP address and the SIA-IP receiver
port in this section.
Not available
Enable SIA-IP
polling
If a telephone number is a "SIA-IP" type number, this
option enables the polling function.
Partitions
You can associate each telephone number with specific
partitions. By selecting the partitions, you can enable/
disable users (who have at least one of these
partitions in common with the telephone number) to
modify the number concerned.
Telephone, Selected
number, "number"
Failed call
A key is available that directly accesses the
programming section of the failed call.event.
Events, Failed call
Table 11-1: Parameters of single telephone number
Table 11-2: Telephone parameters
Parameter Software section Installer menu section
Dial-tone check
The control panel will engage the telephone line and
check for the “dial tone”; if present, the control panel
will start dialing.
Telephone
parameters -
Telephone line
parameters
Parameters
Dial tone check
Pulse dialing The control panel will dial using pulse tone.
Pulse dialing
Telephone line
fault alert
If a “telephone line fault” event occurs, the control
panel will flash the respective icon on the keypad
displays.
Line down signal
Double call
The control panel will override the answerphone
function.
Option available only for PSTN calls.
Double call