INIM Electronics Prime - Chapter 7 Programming arming scenarios; 7-1 Scenario parameters

Programming manual
Programming arming scenarios 43
Chapter 7 Programming arming scenarios
The programming of the arming scenarios (configurations of the arming mode of the Prime
system partitions) can be carried out either via software or from a keypad.
Via software Click-on the Arming scenarios button on the menu on the left, the "Programming" section
will show a list of all the available scenarios and their parameters. Selecting one of these
items allows you to set the parameters of the single scenario by clicking on the button.
Via keypad Type-in Code (Installer) , PROGRAMMING Arming Scenarios
This section allows you to program the various options of the selected scenario.
7-1
Scenario parameters
Table 7-1: Parameters of single scenario
Parameter Software section Installer menu section
Description
Editable field for the description of the scenario.
Arming scenario,
selected scenario
ArmingScenario, "sce-
nario"
Icon
This section allows you to select the icon you wish to
assign to the scenario, by indicating the icon number
(refer to Chapter 15 Keypad shortcut and icon):
Output
The selected output will be activated when the
scenario is applied (via keypad, reader, phone, etc.).
It is possible to use a scenario solely to activate an
output (leaving all actions on the areas null) thus
having the possibility to display different icons on the
keypads to activate different outputs, inheriting the
desired icon from the scenarios.
Partitions
This section allows you to configure the arm/disarm
scenarios of all the partitions managed by the control
panel.
• “-” the current operating mode of the partition will
not be changed.
• Away - the partition will arm in Away mode
(interior and perimeter).
• Stay - the partition will arm in Stay mode
(perimeter only).
• Instant - the partition will arm in Instant mode
(perimeter only with zero delay).
• Disarm - the partition will disarm.
Activate sce-
nario
At the bottom of the section is a key that directly
accesses the programming section of the event that
applies the selected scenario.
Events, ScenarioON