64 Programming the PrimeLAN board
Centrali anti-intrusione
Chapter
13
Programming the PrimeLAN board
The button on menu on the left,
PrimeLAN settings
, allows you to read and program the
PrimeLAN Ethernet interface board.
The programming data read is that of the board, the sent programming data will be saved to
the memory of the board connected to the control panel and not to the control panel memory.
13-1
Programming e-mails
The use of the optional PrimeLAN board provides the user with the possibility of sending e-
mails with attachments relating to the control panel events.
The sending of e-mails on activation or restoral of events depends on the activation of the
“Memory” option of each event (refer to
Table 12-1: Single event parameters
).
Following are the parameters that allow you to configure the e-mail messages, setting the text
and associating it with the occurrence of events and certain recipients:
Table 13-1: E-mail parameters
Parameter Software section
Subject
The “Subject” field of all e-mails - when an e-mail is sent, the PrimeLAN board
uses this parameter as the subject for all type of events.
Depending on e-mail configuration, the “Subject” field can be added with event
type description or a customized text.
E-mail
parameters,
Parameters
Sender
This is the e-mail address of the sender.
Mail Server
Address of the SMTP server of outgoing post.
Port
This is the out port of the post server (SMTP).
Account
This field is for the selection of a domain for which an automatic configuration of
the parameters can be obtained by pressing Preconfigure.
SSL Method
Check box for the selection of the SSL protocol
Timeout (s)
Selection field for the maximum time (from 60 to 300 seconds) within which the
control panel must send an email to the post server.
Authentication
request
Check box for the selection of the authentication type
User name
Password
Authentication credentials of the SMTP server selected above
Id.
Name
Address
Section for the creation of the address book, with the data of the recipients of
the e-mail messages.
This data can be set both in this section and during the assignment of the
recipients to the e-mail message.
It is possible to save up to 20 e-mail contacts.
E-mail
parameters,
Address book
Table 13-2: Email message configuration
Parameter Software section
Event type
Selection field for the selection of type of events to be programmed.
The application will show all the programmable events for the selected type.
Email
configuration
Activation / Restoral
The “Activation” and “Restoral” sections are the same and are intended,
respectively, for the programming of the dispatch of e-mails when the event
occurs (Activation) and when the event ends (Restoral).
Sel
If you click on the respective check boxes of events with this option enabled, you
can program simultaneously the recipient contacts, text and attachments, as
described in the following paragraphs.
If you right click on the header on this column, you will be able to carry out
selections/deselections which involve all the control panel events or all the
events of the same type.
To Next Page
Loading...