76 User functions for the installer
Centrali anti-intrusione
Chapter
18
User functions for the installer
The installer menu on the keypad contains a section that provides the installer with the
functions shared with the user.
Via keypad
1. Access the “User Functions” section of the installer menu:
Type-in Code
(Installer)
, PROGRAMMING User functions
The options available are:
• Activations
•View
• Outputs ON/OFF
• Set date/time
2. Use keys and to select the required function then press
OK
.
ACTIVATIONS
This section provides information regarding the “Cloud registration” option which allows the
Prime control panel to access INIM Electronics cloud service.
VIEW
•
Events log
- allows you to view all the events saved to the log.
•
Alarms log
- allows you to view all the events relating to zone/partition alarm and tamper
saved to the log.
•
Faults log
- allows you to view all the fault events saved to the log.
•
Arm/Disarm ops.
- allows you to view all the arm/disarm operations saved to the log.
•
Nexus status
- allows you to view (on the display) the following parameters of the Nexus
device:
•
System voltage
- allows you to view the voltage:
- measured on the battery
- power-supply of the control panel
- measured on terminal “AUX x”
- measured on terminal “+” of the I-BUS
Table 18-1: View Nexus status on the keypad
Line Display View
1
• Mobile network provider (on the left side)
• if “--” appears, it means that the Nexus is connected to the
BUS
• the letter “C” indicates that data transfer is ongoing
• network technology data (on the left side)
G, GPRS service
3G, UMTS service
H, HSPA service
2
GSM signal reception (value between 1 and 100)
3
Remaining credit balance at the last operation (expressed in
the local currency)
4
Faults present, if present it will be necessary to access the
“View-Faults” section for details.
To Next Page
Loading...