Programming manual
Programming from the Control panel 27
4-3
Programming IP parameters
The connectivity to the Prime control panel LAN is subject to the configuration of the network
itself.
The manufacturer strongly recommends that you contact the network administrator for the
correct configuration.
Squawk
This option activates the sounder for a brief period
during partition stay/away arming and disarming
operations. This audible signal indicates that these
operations have been executed successfully.
Squawk on arming
Sound alarm on
keypad
If enabled, all the system keypads will emit an
audible signal in the event of an alarm or tamper
event on any one of the partitions they belong to.
Alarm on keypads
Enable control
panel anti-dis-
lodgement
This option, enabled by default, provides protection
against tamper on the control panel (tear-off and tilt
detection).
Not available
Wireless super-
vision time
This parameter allows the selection of the supervision
time of wireless devices. On expiration of the
programmed time, any wireless devices which do not
respond will be signalled as lost.
Accepted values: 12 to 250 minutes.
Other parameters,
Wireless superv.
Mains fault delay
This parameter allows you to program the delay,
expressed in minutes, between an “AC Mains failure”
event and “AC Mains failure” event signalling.
Accepted values: 0 to 250 minutes.
Mains fail.Delay
Low battery
delay
This parameter allows you to program the delay,
expressed in minutes, which will be applied before
“LowBattery” events are actually signalled after
detection.
Accepted values: 0 to 250 minutes.
LowBattery delay
BUS speed
This is the BUS communication speed (38.4 / 125 /
250 kbps).
Not available
Outgoing Tele-
phone voice vol-
ume
This parameter allows you to select the volume level
of outgoing voice messages during playback over the
phone.
Accepted values: 10 to 100 minutes.
Other parameters,
OverThePhoneVol.
Incoming Tele-
phone volume
This parameter allows you to select the volume level
of the incoming telephone signal. This is a useful
parameter for the understanding of DTMF tones.
Accepted values: 1 to 80 minutes.
Tel. input gain
Cloud options
Parameter for selecting the communication channel
with the Cloud:
•Use LAN
•Use Nexus
If both are selected priority will be given to the LAN.
Cloud options
Table 4-3: Control panel options
Table 4-4: IP connection
Parameter Software section Installer menu section
IP Address
Subnet mask
Gateway
DNS
Communication
port
Connection parameters
IP connection
parameters,
Connection
parameters
Other parameters,
IP parameters
Web server port
SSL port
Not available
Obtain an IP
address auto-
matically
If this option is enabled the above items are not
required. The protocol used is DHCP.
Parameters,
Enable DHCP
Enable UPnP
This option enables UPnP protocol which automatically
activates “port-forwarding” through the network router
of the communication, web and SSL ports.
Not available
To Next Page
Loading...