92 Default programming
Centrali anti-intrusione
Appendix
A
Default programming
Keypads
• keypad “1” enabled
• all keypads belong to partition 1
• 12 programmed shortcuts: Execute Arming Scenario 1 - Execute Arming Scenario 2 -
Delete telephone calls - Delete memory - Zone activation menu (bypasses) - View alarm
log - View faults - Time/date setting - Voice function menu - Intercom call - Thermostat
menu - Keypad settings menu
nBy Readers
• belong to partition 1
• shortcut programmed on the red LED: Execute Arming Scenario 1
Partitions
• entry time and exit time 30 seconds
• Autoreset memories on arming
• clear call queue on disarming
Terminals
• terminals on control panel: inputs
• terminals on expansion boards: inputs
• terminals on keypads: unused
Zones
• belong to partition 1
• have N.C. balancing (normally closed)
• zones T1 and T2 on the control panel are delayed; all other zones are instant
• unlimited alarm cycles (repetitive)
Outputs
• the output relay is monostable, normally closes, monostable time at 3 minutes
Scenarios
• scenario 1: Away arm partition 1
• scenario 2: Disarm partition 1
Codes
• user code 1 belongs to all partitions
• all other codes do not belong to any partition
• only Code 1 is “Master” user
• enabled on all sections of the user menu
• 8 programmed shortcuts (keys F1-F4): Clear call queue - Activation Output 2 -
Deactivation Output 2 - View zone status - View system status - Enable answerphone -
Enable Teleservice - Teleservice request
• 6 programmed shortcuts (keys 1 to 6): Listen-in - Execute Scenario 1 - Execute Scenario 2
- Stop alarms - Activate Output 2 - Deactivate Output 2
• voice guide enabled
Keys
• belong to partition 1
• Maintenance option enabled
Telephone
• contact numbers 1 to 6 in the phone book have the voice attribute (user)
• contact numbers 7 and 8 in the phone book are for alarm receiving centres CONTACT-ID
• contact number 9 in the phone book has the voice attribute (for the installer)
• contact number 15 is for teleservice
To Next Page
Loading...