INIM Electronics Prime - 10. Associate the shortcuts for the arm;disarm commands and control of expansion outputs to the keyfob command buttons [O]; 11. Enroll the wireless keyfob via the simulated reader of the transceiver ([N]...; 12. Close the programming session after saving the modified data.

Programming manual
Programming example 91
This section will allow you to associate the shortcuts that are not default shortcuts, specifically
“Activate output” shortcuts. to buttons
F3 and F4 then select the respective outputs on the
expansion.
Via software Click-on the Keys button to access the "Programming" section on the right, then select the
key that corresponds to the wireless keyfob by clicking-on the corresponding button
.
The “Shortcuts” section will allow you to associate the shortcuts with the buttons.
11. Enroll the wireless keyfob via the simulated reader of the transceiver (
[N] , identified on
the keypad by the letter “W”).
Via keypad PROGRAMMING Keys, Enroll, "READER 00x W", "Key 00x"
At this point you have 3 minutes to enroll the wireless keyfob by pressing simultaneously
buttons
F3 and F4 .
The positive outcome of the operation will be signalled by 3 blinks on the green LED of the
wireless keyfob and a long audible signal on the buzzer.
CLOSING THE
PROGRAMMING
SESSION
12. Close the programming session after saving the modified data.
Via keypad Press the Esc several times until the following message appears on the display:
EXIT? OK = YES
On pressing OK you will automatically exit the programming session, save the programmed
data and reboot of the control panel.
Via software Using the Write button carry out a write operation.
At the end of this operation the control panel will reboot and it will possible to close the
software solution in progress.
Table 22-5: Shortcuts for wireless keyfobs
Device Button Shortcuts Parameter Default
O
F1
Arm/Disarm Scenario 1 “Away” Yes
F2 Arm/Disarm Scenario 2 “Disarm” Yes
F3 Activate output Gate No
F4 Activate output Garden lights No