88 Programming example
Centrali anti-intrusione
Chapter
22
Programming example
This example describes the installation of a Prime system in a residential building.
It explains the basic programming procedure that must be carried out on the installed devices
and aims at staying as close as possible to the control-panel default programming.
Ideally this procedure directly follows the instructions given in the installation manual for the
first startup of the system
START
PROGRAMMING
The control panel must be enabled for the connection with the Prime/STUDIO software.
1. Start the programming session
Via keypad
Type-in Code
(Installer)
, PROGRAMMING
Via software
Start a new solution by selecting the control panel model such as the one in the installation.
Table 22-1: Installation example
A
Roller blind detector
B
Motion detector
entrance
C
Magnetic contact
entrance door
D
Magnetic contact
garage shutter
E
Motion detector liv-
ing room
F
Magnetic contact
window 1 bedroom
G
Magnetic contact
window 2 bedroom
H
Motion detector bed-
room
I
Reader entrance
door
J
Keypad
K
Reader bedroom
L
Expansion
M
Sounder/flasher
N
Wireless transceiver
O
Wireless keyfob
P
Key
A
B
C
E
G
H
K
L
D
F
M
I
J
O
N
P
To Next Page
Loading...