INIM Electronics Prime - Chapter 3 Programming peripherals; 3-1 Keypads

Programming manual
Programming peripherals 11
Chapter 3 Programming peripherals
3-1
Keypads
3-1-1
Setting up keypads in the system layout
Via software Once the solution of the installation to be designed has been opened, access the “System
layout” section on the right. Here you can select the keypad to be configured and add it to the
configuration by double-clicking on the mouse.
In the section on the left, you can increase the number of keypads in the layout by clicking-on
the Keypads button.
To remove a keypad from the structure, access the programming section by clicking on the
corresponding key in the menu on the left then, from the list displayed, click on the
Delete
button that corresponds to the line of the keypad to be deleted.
Via keypad Type in Code (Installer) , PROGRAMMING Keypads, Enable/Disable
This section allows you to add/remove keypads from the configuration, by means of keys
and .
WIRELESS
KEYPADS
The Prime system provides wizards for the enrolling of wireless keypads.
Via software Click on the Keypads button on the menu on the left, the “Programming” section on the right
will show the list of configured keypads.
Selecting “Keypad type” parameter for one of the keypads allows you to set the keypad
concerned as “Wireless”. This operation makes visible:
•the
Enroll button, which allows the start of the enrollment procedure.
• the “Wireless monitoring” section
Pressing the
Start button starts the monitoring process on the variation of the signal
transmitted by the device and background noise detected over time.
Via keypad Type in Code (Installer) , PROGRAMMING keypads, ChoosePeripheral "keypad", Wireless
Once the OK button is pressed, it is necessary to work through the menu options and enroll
the keypad.
3-1-2
Programming keypads
Programming of the keypads as peripherals of the Prime system can be performed either via
software or by keypad.
Via software Click-on the Keypads button on the menu on the left, the “Programming” section on the right
will provide two sections.
•
Configured keypads , with a list of all the configured keypads. By selecting one of these
items it is possible to set the parameters of the single keypad by clicking on the button.
•
Keypad parameters , section with parameters common to all the keypads.
Via keypad Type in Code (Installer) , PROGRAMMING Keypads, Enablements, ChoosePeripheral
This section provides a list of the available keypads.
Alongside the description of the keypads the following symbols may appear:
•
"<" , that indicate the keypad in use
•
"*" , that indicates a keypad configured on the I-BUS
You can select a keypad for parameter programming from this list.
ChoosePeripheral
KEYP. 001)
KEYP. 002
KEYP. 002 *