INIM Electronics Prime - 21-6 Monitoring sounder;flashers

Programming manual
Monitoring the control panel 85
PERIPHERAL
DETAILS
This section is further divided into several sub-section in accordance with the type of
peripheral.
The
Update button (bottom right) provides details of each peripheral:
• tooltips provide information regarding the peripheral model and whether it is present in the
configuration or not
• the address, firmware version and operating voltage of each of the peripherals present is
shown alongside the icon
Monitoring of the Nexus communicator requires a further selection achieved by ticking the
respective check box.
WIRELESS
DEVICES
The “Peripheral details” section provides the sub-section for wireless devices, selectable via
the label. This section, after clicking-on the
Update button, shows a list of all the wireless
devices connected to the control panel.
The monitoring-operation provides the following feedback for each device:
• an index of the reception quality of the wireless signal
• the percentage of the battery charge
The colour of the values shown also indicates the level of both the signal index and the charge
(red-orange-green).
21-6
Monitoring sounder/flashers
The monitoring phase on the sounder/flashers, both wireless and on the I-BUS, provides
feedback relating to the status sounder/flashers and their descriptions.
Via software Click-on the Monitoring button on the menu bar, then go to the “Programming, Sounder/
flashers” section.
The information relative to each sounder/flasher is shown after the respective icon. If the
sounder/flasher is configured the icon will not be blanked out and will be accompanied by its
description and the status, fault and tamper icons, as follows:
WIRELESS
SOUNDER/
FLASHER
The programming section of the wireless sounder/flashers allows you view their status.
Via software Click-on the Sounder/flashers button on the menu on the left, the “Programming” section
on the right will show a list of configured sounder/flashers. By selecting a sounder/flasher with
the “Wireless” attribute, the “Real time” sub-section will allow you to view the sounder/flasher
status.
Table 21-3: Sounder/flasher icons
Category Icon Notification Category Icon Notification
Alarms
Sounder/flasher loss
Faults
Sounder broken
Sounder active Low battery
Flasher active Battery fault
STATUS LED On
Status
LED input activated
PRG LED On Output FAULT active
Sounder flasher tamper Output TAMPER active
Foam tamper protection
activated
Sounder/flasher undergoing
programming
Wire cutting
Blow torch protection
activated