52 Programming the telephone
Centrali anti-intrusione
Chapter
11
Programming the telephone
The Prime system provides for the programming of all the telephone parameters, both for the
telephone numbers to be called when events occur, and for the telephone line parameters.
ATS DEVICE
The built-in ATS device (alarm transmitting system) provides the following features (in
compliance with EN50131 relating to the notification of information).
• Type B notification apparatus (refer to EN50131-1:2008-02, paragraph 8.6 Notification,
Table 10, page 46, Grade 2).
• The ATS2 notification apparatus specified in the table, is characterized by:
•• Transmission time - classification D2 (60 seconds)
•• Transmission time - max. values M2 (120 seconds)
•• Classification time - classification T2 (25 hours)
•• Substitution security - S0 (no detection of device substitution)
•• Information security - I0 (no detection of message substitution)
Via software
Click-on the
Telephone
button on the menu on the left, the “Programming” section provides
two sections.
•
Telephone numbers
, where all the available telephone numbers and their parameters
are listed. Selecting one of these items allows you to set the parameters of the single
scenario by clicking on the button.
•
Telephone parameters
, where it is possible to set the parameters of the telephone line
and telephone dialers.
Via keypad
Type-in Code
(Installer PIN)
, PROGRAMMING Telephone
In this section it is possible to program both the parameters of each selected telephone
number and some parameters of the telephone line. Other parameters are available in the
sections:
Type-in Code
(Installer)
, PROGRAMMING Parameters
or also
Other parameters
11-1
Telephone numbers
Table 11-1: Parameters of single telephone number
Parameter Software section Installer menu section
Description
This is an editable field for the code user's telephone
number, to be customized by the installer.
Telephone
numbers, selected
number
Telephone, Selected
number, "number"
Telephone num-
ber
Editable field for the contact number (maximum 20
digits).
Accepts also “,” (= 2 second pause), “*” and “#”.
Type
Telephone number type:
• None - the selected number can receive SMS text
messages only
• Voice - the selected number can receive voice
calls and SMS text messages
If the number refers to the Alarm Receiving Centre,
assigns the ARC protocol (reporting format):
• Ademco 10bps, Ademco 14bps, Franklin 20bps,
Radionics 40bps, Scantronic 10bps, CONTACT-ID,
Ademco Express, SIA-IP
Account code
This is the 4-character alphanumeric code which
identifies the caller in reports to the Alarm Receiving
Centre.
To Next Page
Loading...