Programming manual
Monitoring the control panel 87
•• power supply module
•• battery
• the data relating to the power the control panel supplies to the devices in the field:
•• voltages and currents on the “
AUXx
” terminals
•• voltage and current on the I-BUS
21-9
Monitoring Flex5/DAC
expansions
The software monitoring function allows you to view the status of the outputs of all the
connected Flex5/DAC expansions and to work on them.
Via software
Click-on the
Monitoring
button on the menu bar, then go to the “Programming, DAC
peripheral” section.
In this section you must first select the expansion, form those configured, by entering the
relative address in the appropriate field. After clicking-on the
Start monitoring
button this
section will show the following:
• Status of each of the 5 outputs on the expansion:
•• power absorbed by the load, phase shift or power factor and current for alternating
current loads at mains voltage
•• Percentage of the supplied power with respect to the maximum possible, measured
exclusively for dimmable loads.
• Buttons for the activation or deactivation of each single output or to change the voltage
supplied to the dimmer output (this operation is allowed only after the entry of a valid user
code)
• Voltage supplied to the expansion
To Next Page
Loading...