Programming manual
Default programming 93
Zone alarm/tamper events
• relay output activated
• “Other outputs / Sounder/flasher 1” activated
• on activation of the event, calls contact numbers 1 to 8
• on restoral of the event, calls contact numbers 7 to 8
Zone bypass events
• calls to contact numbers 7 and 8
Partition Arming/Disarming events
• calls to contact numbers 7 and 8
Partition Arming/Disarming events
• calls to contact numbers 7 and 8
Emergency button (Panic) events
• on activation of the event, calls contact numbers 1 to 8
Open-panel/Panel dislodgement events and tamper on peripheral
events
• relay output activated
• “Other outputs / Sounder/flasher 1” activated
• on activation of the event, calls contact numbers 1 to 8
• on restoral of the event, calls contact numbers 7 to 8
Blown fuse, A.C. mains failure, peripheral loss and low battery
events
•activated Output 1
• calls to contact number 9 (voice cal to installer)
Sounder/flashers
• causes shutdown on the sounder and the flasher, reset memories on partition (Partition 1)
To Next Page