48 Programming user codes
Centrali anti-intrusione
Partition filter
If this option is enabled, the code concerned can
change the parameters only of codes of a lower level
in the code hierarchy whose partitions are a subset of
its own partitions.
For example, if a code is configured as “Master” with
“Partition filter” and is assigned to partitions 1, 3, 5
and 7, it will be able to enable/disable or change the
PIN of a “User” code assigned to partitions 1 and 5 but
not the PIN of a “User” code assigned to partitions 1,
2, and 3.
Codes, "code", Op-
tions,
Fixed length
If this option is enabled, after entering a valid PIN and
without pressing OK, the user of the code concerned
can activate the shortcut associated with theF12 key,
programmed through the “Shortcuts activated by
function keys” (refer to paragraph 9-3 User code
parameters).
If this shortcut is number 1 (“Arm/disarm”) and all the
partitions assigned to the user code in question are
disarmed, the command will arm them, otherwise it
will disarm them.
If this option is enabled, the user of the code
concerned can access their menu only after pressing
OK and typing-in their PIN.
Voice guide
If enabled on a keypad with a speaker, the voice guide
(after PIN entry followed by OK) will announce the
shortcut descriptions relating to the entered user-code
and the respective number keys on the keypad.
Codes, selected
code, Option
details
AnnounceShortcut
Patrol
If enabled, the code will be able to disable the system
for the pre-set “Patrol time”.
Remote access
If enabled, the code PIN can be used to operate the
system from any remote telephone.
If the code PIN is entered on a remote telephone
keypad, only the shortcuts associated with keys 0 to 9
can be used to:
•Arm/Disarm
•Stop alarms
• Clear call queue
• Delete memory
•Activate output
•Deactivate output
•Listen-in
• Partition status
Recognized valid
user code
A key is available that directly accesses the
programming section of the system arming event of
the selected code.
Codes, selected
code
Events, Valid Code
Table 9-2: Single code parameters
Table 9-3: Code enablements
Parameter Software section Installer menu section
Enablements
This section allows you to enable/disable access to the
various sections of the User Menu.
For details regarding the sections of the user menu,
refer to theUser Manual.
Codes, selected
code, Enablement
details
Codes, "code",
Enablements
Enablement of
outputs
This section allows you to enable/disable each output
the code is authorized to control manually via the user
menu.
Assigned outputs
Shortcuts acti-
vated via func-
tion keys
This section allows you to assign a shortcut to each of
the function keys F1, ... , F12), with the eventual
respective parameter, which will activate when the key
is pressed.
Codes, selected
code, Shortcut
details
ShortcutFunc.Key
Shortcuts acti-
vated by internal
keys
This section allows you to assign a shortcut to each of
the number keys (0, ... , 9) on the control-panel
keypad (with the eventual respective parameter)
which will activate when the key is pressed.
0/9 Key shortcuts
Timers
This section allows you to assign a timer to the code.
The code will be operative only at the pre-set times.
Codes, selected
code, Option
details
Timers
To Next Page
Loading...