INIM Electronics SmartLiving 10100L - Configuration of Graphic Maps

Installation and programming manual
Options and programming methods 103
• GPRS connected - this indicates a successful connection; 10 second after the
visualization of this message, the keypad will return to standby status and the
icon on the second line of the display will blink.
• Connection Error - this indicates a failed connection.
• Error code: xxx - this indicates that code error is the reason for the failed
connection.
TELESERVICE REQUEST
VIA SMS
The request can be made by means of an SMS text message to the Nexus/G of the
installer company; the message format must be as follows:
<xxxxxx> CONNECT <Connection Name> <URL>:<Port>
where:
• <xxxxxx> is the installer code PIN, followed by a blank space
• “CONNECT” is the connection command, followed by a space
• <Connection Name> is the description of the connection (previously described),
followed by a space
• <URL>: is the IP address of the server you wish to connect to, followed by “:”
• <Port> is the connection port
If you intend using the settings configured in the “Programming - GPRS settings”
section (previously described), the last two parameters can be omitted.
After the SMS message has been sent, you must wait until the software indicates that
the connection has initialized.
5. Once initialized, you can carry out the desired Upload/Download operations via
the SmartLeague software.
6. When the programming session is complete, access “Settings – Application data -
GPRS Connection”, then select “Disconnect” to end the connection.
If no read/write operations are carried out for 3 consecutive minutes, the GPRS
connection will end automatically.
7-30Configuration of graphic maps
The SmartLiving supervision functions are based on graphic maps which can accessed
by the end-user through an Alien keypad or web interface.
The maps can be accessed through the SmartLeague software program, as follows:
• Alien graphic maps - select the keypad from the system tree structure on the left,
then select go to the “Programming - Alien Maps” on the right.
• Alien graphic maps - select the keypad from the system tree structure on the left,
then select go to the “Programming - Alien Maps” on the right.
A box, located in the centre of both sections, shows the images of the current maps.
Above this is a button bar that allows you to open new maps or edit existing ones.
The button on the button bar allows you to view either the tree of graphic maps with
objects already inserted, on the left, or the list of objects to insert.
The objects can be added by simply dragging the selected icons and dropping them on
the image.
The button bar also provides buttons for the alignment and resizing of the icons placed
on the map.
By right-clicking on each of the inserted icons, you can edit the icon settings or delete it
from the map.
Table 7-23: Nexus/G - Connection errors
Code Error Code Error
001
GPRS connection error
025 GPRS disconnection error
002 027 GPRS connection error
003 028
Command error - connection not supported (the Nexus
model in use is not GPRS capable)
004 029 GPRS multi-connection error
005 GPRS service not provided by the SIM provider 030
Unexpected remote disconnection (sudden shutdown of the
Smartleague server)
006 Possible APN error 101
Error during TCP connection 007 Possible APN error or GPRS not enabled 102
008
GPRS connection error 103
015
TCP connection error (wrong URL, wrong port, Nexus server
on SmartLeague disconnected or unreachable, etc.)
105 Problems with normal control panel operating capacity
016 TCP disconnection error 106 Generic internal error
024 GPRS connection error 107 GPRS disconnection error