INIM Electronics SmartLiving 10100L - Messages; Default Settings

94 Options and programming methods
Anti-intrusion control panels
7-24 Messages
This section allows you to record (and playback) all the voice messages. The Table in
the Appendix shows all the pre-recorded messages provided by the SmartLogos30M
voice board.
Via Keypad
1. Accessing the “Messages” section:
Type-in Code (Installer PIN) , PROGRAMMING Messages .
2. Use keys and to select the field you wish to change, then use the number
keys ( , etc.) to edit the number.
or
Use keys and to increase or decrease the number.
3. Press .
4. Use keys and to select the instructions for the selected message
thenpress .
Record
Before recording a voice message, you must first select:
• No Message - no recording or playback
• High quality - for superior recording/playback quality
• Average quality - for good recording/playback quality (similar to phone-line
quality).
High quality messages occupy twice the memory space of average quality messages of
the same length.
The recording will start when is pressed, the running recording time (seconds) will
be indicated by a second-counter on the keypad display. If you wish to interrupt the
record/playback operation manually press , otherwise, it will end automatically when
the pre-set time-out expires.
Play
Message playback section. You can adjust the volume during the playback phase using
keys and .
Delete
Delete message section. The control panel will ask for confirmation before deleting the
message, by means of the key.
Via PC
The Parameters settings template of the “SmartLiving System - Voice messages” will allow
you to:
• upload all the voice messages
• download all the voice messages
• format voice board
Select an item from “SmartLiving System - Voice messages” from the tree menu on the
left, then go to the “Programming” template on the right and program the selected
message.
7-25 Default settings
This section allows you to reset to default settings all the control panel parameters,
auto-learn zone balancing values, auto-enroll I-BUS peripherals and restore the event
codes of CONTACT-ID reporting format.
Reset to factory default can be carried out at a keypad via the installer menu (details
follow), or via the control panel PCB, using the following procedure.
1. Disconnect all power to the control panel (mains 230V
~ and backup battery).
2. Short-circuit terminals “2” and “3” of the serial cable connector (refer to Table 2-
8: Mother board - description of parts, I).
3. Power-up the control panel and maintain the short-circuit condition on terminals
“2” and “3” for at least 5 seconds.
4. Restore the short-circuit condition.
Record
0034 sec.
CODING
Empty message
High quality
Average quality
Messages
Record
Play
Delete
PROGRAMMING
Sounders
Language
Messages
Messages
_01 Messages
(Min. 00)
(Min. 485)
Serial port
Terminals to
be short-
2
3