Installation and programming manual
Inim Cloud 57
Via Keypad
Type-in Code
(Installer)
, PROGRAMMING User functions , Activations ,
Cloud enrollment .
Via Alien keypad
Go to the “Settings” section by pressing the button, enter the user code and then
access the “Installer” section, enter the installer code to access the "User Functions -
Activations - Cloud enrollment ”.
2. Enter the 8-digit ID-installer number contained in the confirmation email received
during registration to the Cloud as an installer.
3. The control panel will ask you to specify the owner using the “Inst. Ownership”
option
If the option is selected, the control panel is the ownership of the installer, other-
wise it is the ownership of the “Admin” user.
4. After setting the above-mentioned option and pressing “OK”, the control panel will
carry out the registration to Cloud and the keypad will display the string “WAIT"”.
Note
If the control panel date/time differs by more than 15 minutes from the exact date/time, the
registration process may result negative .
5. The keypad will show the result of the procedure by displaying one of the follow-
ing messages:
• “Account created!”: the control panel has been successfully registered to Cloud
• “Communicat.Error”: generic communication error.
The possible causes may be:
- no Internet connection
- date of manufacture of the control panel is earlier than dd/mm/yyyy
- date/time of control panel different, ahead or behind the exact date/time by
more than 15 minutes
• “Already enrolled”: the control panel is already registered to Cloud
• “Bad ID”: the entered Installer ID code is wrong
• “Panel notEnabled”: the control panel cannot be registered to Cloud
6-4
Control panel connection
The connection to the Inim Cloud service is available for all control panels with a
firmware version not lower than 6.03.
In order to connect the control panel you must have one of the following devices:
• SmartLAN/G, with a firmware version not lower than 6.08
• SmartLAN/SI, with a firmware version not lower than 5.00
• Nexus/G, with a firmware version not lower than 4.00
Note
If the connection to the Cloud is achieved via Nexus/G, the use of this will be exclusively for
communication with the Cloud and therefore it cannot perform any other operations which are
normally available (voice calls, send SMS, respond to commands sent via SMS).
“CLOUD MODE”
In order to assist the installer when programming a SmartLiving control panel
registered to the Inim Cloud service, the SmartLeague software provides an option that,
if enabled, performs a preset of some of the control panel parameters that would
otherwise have to be programmed individually.
Via PC
Start the SmartLeague solution for the control panel, select “SmartLiving System” from
the tree menu on the left, then go to the “Programming” template on the right. There
you will find the “Cloud Mode” option.
If activated, the software will perform the following default programming:
• The “Inim Cloud” will be assigned to telephone number 12 which will no longer be
editable.
• A group of events of various types will be setup and must be communicated to the Cloud
when they occur, these events will no longer be editable
To Next Page
Loading...
