Installation and programming manual
Options and programming methods 59
• Block all system keypads except the one you are using.
• Broadcast the “PROGRAMMING” message to all the keypads.
• Force all the system keypads to standby status.
• Bring the call queue and events log to a temporary standstill, thus there will be no
events saved to the log, no outputs activated and no outgoing calls.
To exit the installer menu, press (o ) and when the system asks: “EXIT? OK =
YES”, press .
Once you exit the installer menu, the control panel will:
• Apply all the new settings and values.
• Restore the I-BUS, reprogramme and make all the peripherals fully operational.
• Restore the call queue, and events log to normal operations.
7-3
Programming via the
SmartLeague software
Certain parameters (for example, relating to zones and outputs) can be programmed
only after the project layout of the system has been completed (refer to paragraph 5-3
Creating a project layout).
1. Go to the “Recent solutions” section and either create a new solution or open an
existing solution, or import the programming data of a real control panel by click-
ing on the key to upload the control panel data.
2. Select the device you wish to configure from the tree menu on the left.
3. Set the parameters in the “Parameters settings” template on the right.
4. To download the data to the control panel, click-on the key.
Note
The limitations described in paragraph 5-3 Creating a project layout
apply during them reading
and writing phases.
This manual is limited solely to instructions regarding navigation through the software
and where to find the various parameters. For full instructions regarding the complete
programming process refer to the SmartLeague Installation and Configuration manual,
supplied with the software.
7-4
Fast programming from
the keypad (Wizard)
SmartLiving provides you (the installer) with a step-by-step guide to fast system
programming via the Installer menu.
The guide consists of a series of questions you (the installer) must answer by means of the
keypad keys. The questions must be answered one at a time in order to programme the
required settings. This programming process does not cover all the control panel
parameters, however, it allows you to program the basic parameters and functions which
permit the system to operate at a basic level.
Starting the Wizard (fast programming process) does not delete any previous
programming, however, it allows you to overwrite it where necessary.
1. Access the “Wizard” section.
Type in the Code
(Installer)
, PROGRAMMING Wizard .
2. Answer the questions asked using keys and to select the field you wish to
change and the number keys ( , etc.) to edit the number.
or
Use keys and to increase or decrease the number.
3. Press to save and continue.
EXIT? OK = YES
18:23 4/30/2017
DASIDASI--
PROGRAMMING
User functions
Other parameters
Wizard
Language
Italian
English
To Next Page
Loading...
