INIM Electronics SmartLiving 10100L - Voice Functions and Intercom; Activations

26 The control panel and peripherals
Anti-intrusion control panels
2-5 AUXREL32 Power
distribution board
The AUXREL32 power distribution board (accessory item) can be used with SmartLiving
1050L and 10100L models. It provides two relays and allows the system to take full
advantage of the current supplied by the switching power supply of the control panel.
Each relay, has a voltage-free contact identified by terminals C1-NO1-NC1 and C2-NO2-
NC2. The relays are activated by the OC1 and OC2 outputs on the control panel. The
activation of each relay is signaled by the on-board LED ([D] for relay 1 and [E] for relay
2).
The 3 pairs of terminals are available, each protected by a resettable fuse (GND/AUX1 –
GND/AUX2 – GND/AUX3), and each capable providing 12V@1A.
G LED - Board power
H LED - Control panel to SmartLAN connection
I LED - Network connection
L LED - Network activity
M LED - Connection speed at 100Mbps
N LED - transmission/reception over BUS RS232
O LED - Network collision
P Fixing hole and earthing
Q μSD-card (not included)
Table 2-41: SmartLAN - description of parts
E F
H
D
A
B
G
SmartLAN/G
P
Q
Table 2-42: AUXREL32 - electrical and mechanical features
Power supply voltage 12V
Maximum current 3A
Operating temperature from -5 to +40°C
Dimensions 42 x 78 x 20 mm
Table 2-43: AUXREL32 - description of parts
A Terminal board
B 12V connector
C OC1/OC2 connector
D Relay LED 1
E Relay LED 2
F 12V present LED
G Mounting screw hole
H OC1/OC2 connection wire (included)
I 12V power wire (included)
Table 2-44: AUXREL32 terminal board
n. icon/identifier description
1-2-3 C1-NO1-NC1 Free voltage relay 1
4-5-6 C2-NO2-NC2 Free voltage relay 2
7-9-11 AUX1-AUX2-AUX3 12V@1A screw terminals
8-10-12
Negative power terminals (Nega-
tive or GND)
A
C
E
F
D
G
A
G
B
G
H
I