Installation and programming manual
Options and programming methods 83
If you wish to activate a telephone call and output when at least two detectors out of 5 go into
alarm status.
• The programmable event must be programmed as (“Alarm zone 1” + “Alarm zone 2” + “Alarm zone
3” + “Alarm zone 4” + “Alarm zone 5”)>=2
( E0000 + E0001 + E0002 + E0003 + E0004 ) >= V0002
• Associate the programmable event with the telephone call you wish to receive and the output you
wish to activate.
7-12
Timer
This programming section deals with the 10 system Timers.
Each timer can be programmed to manage:
• the partitions that codes and keypads belong to and have access to the
programming process of the timers via the user menu.
• two scheduled activation times (“ON”) for each day of the week.
• two scheduled deactivation times (“OFF”) for each day of the week.
The SmartLeague software program will allow you program up to 15 exceptions.
A timer can be associated with a:
• Partition - if a partition is associated with a timer which controls automatic-arming
operations (refer to paragraph 5-4 Activations in the User's Manual), it will arm
when the timer switches ON and disarm when the timer switches OFF.
• Code - if a code is associated with a timer, it will be enabled to operate the system
when the timer switches ON, and disabled when the timer switches OFF.
• Key - if a key is associated with a timer, it will be enabled to operate the system
when the timer switches ON, and disabled when the timer switches OFF.
In order to associate timers with any of the above-mentioned objects, it is necessary to
access the respective control-panel programming section.
Note
The timers must be enabled/disabled by the user (refer to paragraph 5-4 Activations in the User's
manual).
On exiting the programming session (via keypad, computer or modem) all the timers will be
enabled automatically. Therefore, if it will be necessary to disable the timers as required.
Via Keypad
1. Accessing the “Timers” section:
Type-in Code
(Installer PIN)
, PROGRAMMING Timers .
2. Use keys and to select the Timer thenpress .
Once the timer has been selected, it will be possible to activate the partitions for
access to programming or the activations for every day of the week:
3. Select the “Partitions” option and press .
4. Select the partitions with access and enable or disable them using and
.
5. Press to confirm and exit.
3. Use and to select the day of the week.
4. Select an activation or a restoral of the timer.
5. Set the selected time (expressed in hours and minutes) by means of keys and
then, using keys and select the number.
6. Press to confirm and exit.
Note
It is also possible to programme timer activation or restoral only.
If you do not wish to programme the timer activation or restoral setting, enter “--:--” in the field
you do not wish to program.
TIMER 001
PARTITION 001
PARTITION 002
PARTITION 002
TIMER 001
Partitions
Sunday
Monday
PROGRAMMING
Telephone
Events
Timers
Timers
TIMER 001
TIMER 002
TIMER 003
TIMER 001
PARTITION 001
PARTITION 002
PARTITION 002
To Next Page
Loading...
