Installation and programming manual
Options and programming methods 93
•• Activate Output
•• Deactiv. output
•• Overtime
•• Teleservice req.
•• View faults
Prog. Address
This section allows you to activate the address programming phase for nBy/S and nBy/X
readers.
Follow the instructions for addressing readers in paragraph 3-3-5 Addressing nBy readers.
Via PC
7-22
Sounders
This section allows you to programme the parameters of the sounderflashers connected
to the I-BUS and enroll wireless sounderflashes.
Wireless sounderflashers can be programmed via the SmartLeague software
programme only.
Via Keypad
Type-in Code
(Installer PIN)
, PROGRAMMING Sounders .
Enable/disable
This section allows you to add/remove sounderflashers from the I-BUS configuration, by
means of keys and .
ChoosePeripheral
This section allows you to programme the various options of the selected
sounderflasher.
•
Wireless
- this section allows you to start the enrolling process of the wireless
keypad.
• Description - editable field for the name of the sounderflasher.
Via PC
7-23
Language
Via Keypad
This option allows you to select the language the system uses in the User and Installer
menus for the descriptions of events, faults, etc. However, the edited descriptions of the
various system elements such as: zone, partitions, outputs, codes, descriptions will
remain unchanged.
Use keys and to select the desired language and to confirm.
Table 7-17:
Readers - via SmartLeague software programme
Option Part of the system Template/section
Enable/disable
/ Project
ChoosePeripheral
Proximity readers - select the reader Programming
Prog. Address
Proximity readers Programming
Table 7-18:
Sounderflashers - via SmartLeague software programme
Option Part of the system Template/section
Enable/disable
/ Project
ChoosePeripheral
Sounders - select the sounder/flasher Programming
PROGRAMMING
Keypads
Readers
Sounders
Sounders
Enable/disable
ChoosePeripheral
PROGRAMMING
Readers
Sounders
Language
Language
Italian
English
To Next Page
Loading...
