Installation and programming manual
Installation 47
3-10-3
SmartLAN
The SmartLAN board, available with SmartLAN/G and SmartLAN/SI versions,
allows SmartLiving control panels to extend their connectivity to Ethernet and
Internet networks.
The operating capacity of the SmartLAN board depends on the proper
configuration of the networks it is connected to. Therefore, if you are installing
a SmartLAN board, it is necessary to contact the network administrator in
order to configure it correctly.
The figure opposite shows the SmartLAN/SI board mounted inside the box. If
you intend installing this board, work carefully through the following steps.
1. Disconnect the primary power supply to the control (230V~) and the
backup battery.
2. Remove the earth connection screw [A] (Table 2-6: Control panels -
description of parts, G
) from its location and replace it with the metal
spacer (included).
3. Align the screw location on the board with the support and serial connec-
tor on the backplate [B], with the connector on the SmartLiving board
(Table 2-8: Mother board - description of parts, I).
4. Fasten the screw [A] on the support.
5. Insert the board power jumper between pins 1 and 2 of the connector (Table 2-8:
Mother board - description of parts, E).
For SmartLiving 515 model without this connector, use the cable jack and connect
it to the connector [C], then connect the free red [D] and black [E] wires respec-
tively to terminals “+” and “-” of the control panel BUS.
6. Power up the control panel by reconnecting the mains power (230V
~) and backup
battery.
Note
It is important to note that the e-mail service does not guarantee delivery time of e-mails and
their attachments nor even their final delivery.
3-11
IP and Internet Connectivity
3-11-1
Configuring an IP network
Minimum configuration requirements:
• 1 router/modem connected to the Internet. The router/modem must be “port
forwarding” capable in order to route external connections.
• 1 SmartLAN connected to the router/modem.
In addition, for programming purposes, a SmartLeague equipped PC must be linked to
the SmartLAN (point to point connection with crossed Ethernet cable or via router
connection).
A good knowledge of networking and TCP/IP protocol is required during the SmartLAN
board configuration and the Internet connection phases.
IP ADDRESS
The IP address must uniquely identify each peripheral device connected to a network such
as, for example, each computer connected to the company network or directly to the
Internet.
The IP address of the SmartLAN is a “static” address and cannot be assigned
automatically. You can assign the IP address, set at default as 192.168.1.92, via the
SmartLAN programming page in the SmartLeague software programme. The PC used
for the initial programming of the SmartLAN must have an IP address of the same
address class 192.168.1.xxx (for example, 192.168.1.123).
Successively, it will be possible to change the IP address of the SmartLAN, therefore, it
will be the task of the network administrator to supply one suitable for the requirements
and potential of the configured network.
SUBNET MASK
This mask specifies which address class can communicate with the SmartLAN board
and, consequently, which peripherals to connect to.
This parameter, which must be requested from the network administrator
(255.255.255.0 at default), allows the SmartLAN to reach all the peripherals with
address class 192.168.1.xxx.
TCP/IP PORT
This is the identifier of a service which may have a single peripheral connected to the
network. SmartLAN uses two TCP/IP ports:
A
B
C
D
E
To Next Page
Loading...
