Installation and programming manual
Installation 45
3-8
Learn zone balancing
Once you have completed the wiring and configured the balancing of all the zones, you can
instruct the control panel to save all the related parameters automatically, by activating the
Learn zone bal. option (refer to paragraph 7-25 Default settings, Learn zone bal.).
3-9
Connecting the outputs
It is possible to set up the outputs to activate in response to the events the control
panel manages.
For the connection of the outputs to terminals “T1” and “T2” of the Air2-MC100 device, refer
to the Air2-BS200 Installation Guide.
3-9-1
Connecting the sounders
In the event of intrusion alarm, the control panel activates the output which is
connected to the audible/visual signalling devices. The relay output on the control panel
motherboard is the alarm output which is most commonly used to drive a self-powered
sounder.
The following wiring diagram shows the connection of a self-powered sounder (IVY
manufactured by INIM) and an indoor sounder.
3-9-2
Connection open-collector
outputs
With the exception of the relay output, all the control panel and Flex5/P and Flex5/U
outputs are “open collector” outputs:
• OC1 and OC2 are open-collector outputs that sink maximum currents in accordance
with the Table 2-2: Control panels - electrical and mechanical features.
• All the terminals configurable as outputs are open-collector outputs that sink a
maximum current of 150mA.
Below is a diagram illustrating a series of typical connections for the activation of a load
when a Normally Open output closes to GND ( ).
Patent
pending
To Next Page
Loading...
