Installation and programming manual
Options and programming methods 85
Timers
Select the timer you wish to associate with the “auto-am” operations.
Note
Remember to enable auto-arm partition in the section:
User menu
,
Activations .
Forced auto-arm operations may occur, generated by events active at the time of the
auto-arm operation.
Options
• Auto-resetMemory - if enabled by means of the key, each partition arming
operation will reset the partition alarm/tamper memory automatically.
• Auto-arm STAYmode - if enabled by means of the key, the partition will arm
in Stay mode at the pre-set auto-arm time. If disabled by means of the key,
the partition will arm in Away mode at the pre-set auto-arm time.
• StopTelOn Disarm - if enabled, the call queue will clear when the partition disarms.
Via PC
Select an item from “SmartLiving System - Partitions” from the tree menu on the left,
then go to the “Parameters settings” template on the right.
7-14
User Codes
This programming section deals with the user code options/parameters.
The user code PINs must comprise 4, 5 or 6 digits. The PIN of user code n. 1 is “0001”
at default. The PINs of the successive user codes are “0002”, “0003”, etc.
Via Keypad
1. Accessing the" Codes” section:
Type-in Code
(Installer PIN)
, PROGRAMMING Codes .
2. Use and to select the code then press .
Description
This is an editable programming field for the code user's name.
Partitions
Select the partitions the user code is assigned to. Press , to enable the partition
and to disable it.
Options
Use and to enable/disable the code options.
• Partition filter - if this option is enabled, the code will be able to change the
parameters only of codes with a lower rank in the system hierarchy whose partitions
are amongst the partitions assigned to the code being programmed.
For example, if a code is configured as “Master” with “Partition filter” and is assigned
to partitions 1, 3, 5 and 7, it will be able to enable/disable or change the PIN of a
“User” code assigned to partitions 1 and 5 but not the PIN of a “User” code assigned
to partitions 1, 2, and 3.
• Text menu and User menu - the combination of these two options allows
immediate visualization of the menu screens on the keypad displays after
acceptance of a valid user PIN. Refer to the following table.
Table 7-12:
Combinations “text menu” and “user menu”
Case Text menu User menu Description
A
Disabled Enabled
Accesses the user-menu (shown as a list of operations the user
is enabled to perform); at this point the user can scroll the list
using and and select the required option.
B
Disabled Disabled
Visualization of the user-icons associated with function keys
, ..., ; at this point the user can press the required
function key and activate the associated shortcut.
C
Enabled Disabled
Shows the descriptions of the personalized user-icons associ-
ated with function keys. The descriptions of the shortcuts are
shown in place of their associated icons. The user can use
and to scroll the list of shortcut descriptions and
select the desired shortcut, which can be activated by means
of the key.
D
Enabled Enabled The same as “
C
”
PROGRAMMING
Timers
Partitions
Codes
Codes
CODE 001
CODE 002
CODE 003
User Code
User Code
Manage alarms
Arm/Disarm op.
Voice functions
To Next Page
Loading...
