86 Options and programming methods
Anti-intrusion control panels
Note
In all methods of access (A, B and C), the key allows you to access/view the other cases in
succession, see figure.
• AnnounceShortcut - if enabled on a voice capable keypad, the descriptions of all
the shortcuts assigned to the code and associated with the number keys will be
announced after acceptance of the entered PIN.
• Remote access - if enabled, the code PIN can be used to operate the system from
any remote telephone.
If the code PIN is entered on a remote telephone keypad, only the shortcuts associated
with keys 0 to 9 can be used to:
•• Arm/Disarm
•• Stop alarms
•• Clear call queue
•• Delete memory
•• Activate Output
•• Deactiv. Output
•• Listen-in
•• Arming status
Any other type of command will have no effect.
•
Patrol
- if enabled, the code will be able to disable the system for the pre-set “Patrol time”.
•
Fixed length
- if enabled, after typing in a PIN and without pressing the key, the user
will be able to activate the shortcut associated with function key “F12”, programmed via the
“F1/4KeyShortcuts”, described later.
If this shortcut is number 1 (“Arm/disarm”) and all the partitions assigned to the user code
in question are disarmed, the command will arm them, otherwise it will disarm them.
A user code with this option enabled has access to its own menu only after pressing the
key and PIN entry.
F1/4KeyShortcuts
This section allows you to programme up to 12 shortcuts associated with keys , ...,
. After valid PIN entry, the keypad will show the icons that correspond to keys
, ..., and which are associated with these shortcuts. Press the corresponding
key to activate the respective shortcut.
0/9 Key shortcuts
This section allows you to program up to 10 shortcuts associated withkeys , ...,
. After PIN acceptance, the code user can activate the shortcut by pressing the
respective number key.
To assign the shortcuts to the function keys, work through the following steps.
1. Use keys and to select the key you wish to associate with the shortcut
then press .
2. Press then, using keys and , select from the “Type” list the shortcut
you wish to associate with the function key.
3. Press to confirm and exit.
4. If the shortcut is associated with “Arm/Disarm” operations, the application will
ask you to select a scenario. If the associated shortcut is “Activate output” or
“Deactiv. output”, the application will ask you to select the output.
Assigned outputs
This section allows you to enable/disable the outputs the code user can control
manually via the:
User
menu, Outputs ON/OFF .
1. Use keys and to select the desired output.
2. Use keys and to enable/disable manual control of the output for the
code concerned.
3. Press to confirm and exit.
It is possible to program a certain number of outputs which can be activated or
deactivated via keypad without entering a user code. For further details refer to
paragraph 7-28 Activating outputs without authentication.
Timers
This section allows you to assign a timer to the code. The code will be operative only at
the pre-set times.
To Next Page
Loading...
