Installation and programming manual
Options and programming methods 87
Type
This section allows you to assign a level (rank) in the system hierarchy to the selected
code (refer to paragraph 1-6-2 User).
Note
The default level of code number 1 is “Master”; the default level of all the other codes is “User”.
Enable/disable
This section allows you to enable/disable access to the various sections of the User
Menu.
For further details regarding the sections of the User Menu, refer to the User Manual.
The programming steps are identical to those of “Outputs ON/OFF”.
Via PC
Select an item from “SmartLiving System - Users - Codes” from the tree menu on the
left, then go to the “Parameters settings” template on the right.
7-15
Installer codes
This section allows you to program the functions of the 2 installer codes. The user code
PINs must comprise 4, 5 or 6 digits.
Via Keypad
Type-in a valid code
(Installer)
, PROGRAMMING Installer code .
ChangeInst. PIN 1
For security reasons, you must change the PIN of the primary installer code (type-in
twice). The PIN is “9999” at default.
ChangeInst. PIN 2
For security reasons, you must change the PIN of the secondary installer code (type-in
twice). The PIN is “9998” at default.
Inst.code 2
Use keys and to enable/disable the sections of the installer menu the
secondary installer code can access.
Note
In this section, the secondary installer code can access Inst.CodePIN2 section only.
7-16
Keys
This section will allow you to programme the parameters of the digital keys and Air2-
KF100 wireless keyfobs (for details regarding the wireless keyfobs, refer to the Air2-
BS200 Transceiver Installation guide).
Via Keypad
Type-in Code
(Installer PIN)
, PROGRAMMING Keys .
Enroll
Each digital key and wireless keyfob must be enrolled separately on the system in order
to allow it to operate. The enrolling procedure is as follows.
1. View the readers in the control panel configuration. Select the reader you wish to
use for the enrollment of the key/s, then press . If you select a reader simu-
lated by the Air2-BS200, a “W” will be shown at the end of the description.
2. Select the digital key you wish to enroll and press . If you are using an nBy/S
or nBy/X reader, all the LEDs will begin to blink to indicate that it is ready to
enroll the key.
3. The keypad will indicate the current description of the digital key concerned.
4. Hold the digital key in the vicinity of the reader and then move it away. For Air2-
KF100 wireless keyfobs, press simultaneously keys 3 and 4.
5. The keypad will emit a beep to confirm that the digital key has been successfully
enrolled. If you are using an nBy/S or nBy/X reader, the red LED will go On. The
digital key description will go to the next key automatically. This method (from
step 4.) allows you to enroll as many digital keys as the system requires.
To Next Page
Loading...
