INIM Electronics SmartLiving 10100L - Remote Access

Installation and programming manual
Installation 49
3-11-3 Remote access
To establish external communication with the SmartLAN/G web server via browser
(Firefox, Opera, Internet Explorer, etc.), type in the configured public IP address of the
router followed by the number of the external forwarding port, as follows:
• http://www.casamia.com:8080 (in the case of domain associated with static public
IP)
• http://casamia.dyndns.org:8080 (in the case of registration with dyndns.org with
dynamic public IP)
VIA SMARTLEAGUE In order to allow remote communication with the SmartLAN, it is necessary to set the
configuration on the SmartLeague (IP address of the router and external rerouting
port).
VIA MOBILE DEVICES For remote access to the SmartLAN/G web server, type on the browser on your mobile
phone the public IP address of the configured router followed by the number of the SSL
web port, as follows:
• http://www.casamia.com:443 (in the case of domain associated with static public
IP)
• http://casamia.dyndns.org:443 (in the case of registration with dyndns.org with
dynamic public IP)
3-11-4 Connection test
The SmartLiving control panel can carry out an IP network connection test by making
link connection attempts to a precise IP address.
The SmartLeague software programme will allow you to set the test parameters. These
parameters can be found in the “Programming - IP connection test parameters” section
relating to the “SmartLiving system”:
• IP Address, Port - Address IPv4 and port where the connection attempts are to be
directed.
• Interval - an intervening period (expressed in seconds) between the test
connections. If set at “0” the connection test will be disabled
• Number of attempts - number of connection attempts made during each test
If the connection test is enabled and fails (i.e. the control panel is unable to achieve an
IP connection during the programmed number of attempts), the “IP conn. loss” event
will be generated.