16 The control panel and peripherals
Anti-intrusion control panels
Keypad terminals:
Terminals T1 and T2 can be configured as:
• Input (also as Rollerblind or Shock)
•Output
•Double zone
•Supervised Output
The keypad package contains a sticker (to be located under the keypad flip) which can
be used to note down the keypad address or label, its location, the partitions it controls
and any phone-contact numbers.
2-3-2
Aria/HG keypad
• Backlit graphic display
• Icon Easy4U interface
• Brightness sensor
•4 indicator LEDs
• Signal buzzer
• Inertial tamper protection
• Mounts to “503” outlets
• Thermometer and chronothermostat function
• 2 Input/Output terminals
• Microphone and loudspeaker for voice functions
• Built-in proximity reader
Tab ell a 2-1 5:
Joy - terminal board
n. icon/identifier description
1+
Termi n a l “
+
” for the I-BUS connection
2D
Termi n a l “
D
” for the I-BUS connection
3S
Ter m i n al “
S
” for the I-BUS connection
4-
Termi n a l “
-
” for the I-BUS connection
5T1
Screw terminal of keypad terminal T1
6
Negative power terminal (Negative or GND)
7T2
Screw terminal of keypad terminal T2
8
Negative power terminal (Negative or GND)
1 2 3 4 5 6 7 8
A
Tab ell a 2-1 6:
Aria/HG - electrical and mechanical features
Voltage
from 9 to 16V
Typical current draw
90mA
Terminals configurable as OC outputs
2
Maximum current draw per terminal
150mA
Dimensions (W x H x D)
140 x 115 x 27mm
Weight
228g
Tab ell a 2-1 7:
Aria/HG - description of parts
A
Display
B
Brightness sensor
C
LED
D
Microphone
E
Proximity reader
F
Cable connector
G
Speaker
H
Counter support
I
Wall bracket support
J
Screw location
K
Backlocking grips
L
Mounting screw location
M
Cable entry
I
Aria/HG - front
A
B
D
E
C
Aria/HG - back
F
J
G
H
I
To Next Page
Loading...
