INIM Electronics SmartLiving 10100L - Page 18

18 The control panel and peripherals
Anti-intrusion control panels
You can connect Code/G and Concept/G keypads using the connector on the back of the
device, using either the 6 wire cable (included), or the KB100 terminal board included in
the deep-bracket kit (accessory kit).
2-3-4 Alien/G and Alien/S touch screen
keypads
• Touch-screen
• Protection against removal and dislodgement tamper
• Input/Output terminals (Alien/G only)
• Compatible with all SmartLiving 5.0 and higher models
• Thermometer and chronothermostat function
• Microphone and loudspeaker for voice functions
• Built-in proximity reader
• System interface with I-BUS and RS485 BUS
•USB Interface
• SD card interface
• Photoframe function with images on SD card
• Background customization with images on SD Card
• Skin selection
•Black or white
Table 2-21:
Connection cables - KB100 terminal board
n.
Wire
colour
KB100 ter-
minal
board
description
1Red + Wire/Terminal “ + ” for the I-BUS connection
2Yellow D Wire/Terminal “ D ” for the I-BUS connection
3Green S Wire/Terminal “ S ” for the I-BUS connection
4Black - Wire/Terminal “ - ” for the I-BUS connection
5Blue T1 Wire/terminal of keypad terminal T1
6Black Negative power wire/terminal (Negative or GND)
Table 2-22: Brackets - description of parts
I Wire entry
L Wall-mount screw locations
M Flush-mount screw locations
N Backlocking grips
6 wire cable KB100 - terminal board
I
L
Mounting bracket
L
M M
M
M
N
N
N
N
N
KB100 - deep mounting
bracket
I
L
L
M M
M
M
N
N
N
N
N
L
L
Table 2-23: Alien - description of parts
A Display
B Microphone
C Proximity reader
D Touch pen holder
E Closure hooks
F Backlocking grips
G Securing screw
H Cable entry
A
Alien/S - front
B
C
G
Q
R
Alien/S - back
G
J
J
J
J
M
Q
R
U
W
Alien/S - mounting bracket
F
F
F F
H
K
K