22 The control panel and peripherals
Anti-intrusion control panels
The Flex5 expansion board terminals are as follows:
2-3-7
Flex5/DAC alternating current output
expansion
The Flex5/DAC provides 5 terminals for controlling both AC and DC loads.
Each terminal can be configured as an output with the following attribute type:
• Relay, dry contact for AC or DC devices of up to 10A
• TRIAC ON/OFF, electronic contact that functions as a relay for AC devices up to 4A
maximum
• TRIAC dimmer, dimmer contact for power-choke type AC devices of up to 4A
For the technical description and installation of the Flex5/DAC refer to the manual
included in the respective package.
2-3-8
Air2-BS200 Transceiver
The Air2-BS100 two-way wireless system integrates directly with all models of the INIM
intrusion control panel range.
Description of the Air2 system devices:
• Air2–BS200/50 transceiver module, 50 terminals
• Air2–BS200/30 transceiver module, 30 terminals
• Air2–BS200/10 transceiver module, 10 terminals
• Air2–MC100 magnetic contact with two I/O terminals, in white or brown
• Air2–MC200 magnetic contact with shock and tilt sensor in white or brown
• Air2–KF100 4 button remote-control key
• Air2–FD100 smoke detector
• Air2-Aria/W keypad with graphic display
• Air2-Hedera outdoor sounder, in white or chrome effect
• Air2-DT200T dual technology curtain detector, in white or brown
• Air2-XIR200W PIR detector, 12m
• Air2-XDT200W dual technology curtain detector
• Air2-UT100 universal transceiver
• Air2-ODI100W outdoor wireless dual-infrared detector
• Air2-OTT100W outdoor wireless triple-technology detector
For the technical specifications and installation instructions relating to Air2 devices refer
to the manuals supplied with each device and to the Air2-BS200 installation manual.
2-3-9
Aria/W Keypad and Hedera sounder
The SmartLiving control panel can manage up to 4 Aria/W keypads and 4 Hedera
sounders for each Air2-BS200 installed. However, each control panel model supports a
maximum number of keypads and sounders which must be respected.
During the addressing phase it is necessary to use free addresses only and to ensure
that no other keypads (Aria/HG, Joy, Concept, NCode or Alien) are present at the
address of the Aria/W keypads, or other sounders (Ivy-B) at the address of the Hedera
sounderflashers to be included in the configuration.
2-3-10
IVY sounder/flasher
The self-powered sounders from the IVY outdoor series are controlled continuously by a
microprocessor which monitors all the device parameters to ensure performance and
reliability at all times.
INIM Electronics s.r.l. also offers Ivy sounderflasher models which are connectable via I-
BUS cable, which permit the programming and control of SmartLiving intrusion-control
panels, for extended customization of the security system.
Table 2-32:
Expansion terminal board
n.
icon/identi-
fier
description
1-2-3-4 + D S -
I-BUS connection terminals
5-6 +AUX
12V ancillary power source terminals
7-9-11-
13-15
T1-T2-T3-
T4-T5
Screw terminals for expansion terminals: T1, T2, T3, T4
and T5
8-10-12-
14-16
Negative power terminals (Negative or GND)
To Next Page
Loading...
